![]() ![]() This will loosen the bezel and you can begin to work your way down until the whole bezel lifts up. Do this very slowly and carefully, as there is a cable you’ll need to disconnect! Place your thumb on the edge of the display unit and your fingers on the back side of the iMac. From there, push your thumb down as your pull up your fingers. The best way to do this is by starting in the upper corners. Be aware that the four screws along the bottom are longer than the rest, so make sure you put them back in the correct locations.Īfter you remove these screws, it’s time to remove the whole front bezel. Next, there are twelve T8 Torx screws around the edge of the display that need removed. If you’re worried about scratching it, place it on a soft surface away from the work area and then lay a towel or sheet over it to prevent it from collecting dust. The glass is simply held on by magnets, so all you have to do is lift straight up and the glass panel will come right off. ![]() Next, take your suction cups and place them in opposite corners of the screen, making sure to lock them in place so that they grab on to the glass.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |